fysetc f6 v1.3 board mount

This is a din rail mount for the Fysetc F6 V1.3 board.
you will need M3x3x4.6 heat inserts, the length can vary by 1 mm but the width (the last number) should be around the same for strength.
you need 2 din clips and a main mount, sideways is recommended as the wide one takes up quite a bit of space, and i made this for my ender 3 ng, an ender 3 to corexy conversion, and it couldn't fit the din rail with v1, as it is quite wide especially with my larger power supply. It's not really a v2, just has one less mistake and uses a bit more plastic.
Ignore the cardboard in the picture, that's just because when i first printed it the heated insert standoffs broke off, so it was too close to the back screws. Now the standoffs are more bulky, so it shouldn't happen.