Hello, I've modeled and printed adapter, which helps in placing honeycomb H44 (44 cm x 44 cm) under my Laser Engraver Mecpow X3 Pro. I am not sure if it can fit to other models, but if I get information in future, I will update all information.
After you done printing it, you should print square with measurable offset (I've printed mine with distance 5 mm from left and bottom edge), and then measure it, like on photo:
Here for example we have 5.18 mm instead of 5 mm. This means our bottom offset should be reduced by 5.18 mm - 5.00 mm = 0.18 mm.
When we measure both (left and bottom offset) we go in Lightburn to Edit→ Dervice Settings (photo):
And changing Laser offset according to counted values.
(Remember, when you measured values lower than 5 mm offset is positive, when they are bigger than 5 mm - offset will have negative value).
The author marked this model as their own original creation.