Mid Century MagSafe Iphone Stand

I designed an Iphone MagSafe stand inspired by mid century aesthetic!

Print Settings

Rafts:

Doesn't Matter

Supports:

Yes

**Resolution:**

.2mm Layer Height

Infill:

15-20%

**Filament:** Protopasta HTPLA

Notes:

Print Settings
-.2mm layer height
-15-20% infill
-3 perimeters
-Support on Bottom and Top

Assembly
-Print all parts
-Snake the magsafe charger cord through the Top and press fit the dish in place with the cord facing down
-Snake the cord through the Bottom
-Screw in the connector through the bottom
-Once all parts are together you can spin the top to wind the cable or pull on the end to unwind the cable!

Category: Mobile Phone