Patio/French Door handle hook

A simple hook to go on to the handles of a set of Patio/French doors to keep them from blowing in the wind when you don't want the doors fully open.

It was printed using Creality Hyper PLA with the following parameters: -

Standard quality, layer height of 0.2mm, 300 mm/s speed, 0.6mm shell thickness, 15% infill density.

With these settings it should print correctly, although it did feel a bit lightweight in my hand… It's worked fine these last couple of months but if I was to print again I'd use a 0.8mm shell and 25% infill.

When I design a longer version for our other doors I'm going to print it with the above settings to see if I like the feel of that better!

Feel free to experiment yourself with the print settings and show the results.

Resized the centre hole to suit my handle & modified the length.