Phomemo M110/M220 roll inner tube

Recently, when I was trying to buy printing paper for my Phomemo M220, I noticed that there are many types of paper that belong to the M02/M02Pro/04S etc. printer ranges that are not available even though they are theoretically compatible in size.
The difference is the diameter of the inner tube, which in these models is smaller so we couldn't pass the paper holder through.

I have created a design with the same dimensions as the rolls of the M110/220 range to pass the thermal paper through them and be able to use any paper of any brand in the printer as long as it is within the limit of the maximum measurements supported by your model. I know it is a stupidly simple design, but it is always better to have it done for you! ;P

To do this you will need to completely unroll the paper from the original tube as the end of the paper is stuck to the tube with a bit of double-sided tape. You put a bit of new tape on the printed tube and roll it up. It is a bit cumbersome but it works.

With this we save money by buying third-party paper or we even have access to tons of continuous and specific paper from the other Phomemo models, which is cheaper.

(Note: you must print it vertically to avoid bridges and modify the design by adding or subtracting length depending on the paper you are going to put in it)

Thanks everybody!