The controller has some levers, where can I download them?
Nintendo Switch Steering Wheel Adaptive
I made it adaptable to Joy-Cons both with and without protection case.
103
448
5
2278
updated
September 12, 2024
Makes
Comments
Very good model. I like it. My kids like it. It is handy and works great.
I printed in PLA without any support and turned out great.
NOTE: Even the smaller variant is a bit big for very small kids. My 4 year old son wasn't able to use the wheel. It was too big for his hands but my bigger kids (8 and 10) are very happy with the ergonomics of the model and love to use it :)
Hi how did you print this with no supports? im concerned the bottom of the wheel wont connect did you print this as it loads into slicer with the flat down?
Welcome addition to mario kart night.
Performs well for me, really helps one handed steering while road raging at the Italians and all their pesky banana peels.
May have to print again in PETG if it doesn't help my fiancée on rainbow road.
Printed in Overture PETG. Looks and prints great! I noticed the screw was really tight on my first print, so I made another at 98% scale which worked great. I'll print the paddles next!
