The Gamesir G8 Plus bluetooth controller is just a little too wide to hold the Nintendo Switch in portrait mode so I designed this sleeve to fill in the gap. I started with the holder from https://www.printables.com/model/19878-switch-portrait-vertical-flip-grip-with-locking-me, removed the Joy-Con grips and added grooves on both sides for a secure fit with the Gamesir G8 Plus. This allows you to securely clamp in the Switch at your preferred height.
This sleeve was designed for the original non-OLED Switch.
Prints flat on the back without the need for supports. I used a 0.20mm height and 15% infill (gyroid).
The author marked this model as their own original creation.