Fastening Clips for Blumat Tubes

You've just got your Blumat irrigation system, are eager to set it up but then you've noticed that the black tube is way to stiff to bend nicely around corners or even stay remotly where you've put it? Then you've probably didn't catch the note on putting that tube into warm water and now you're in the same situation I've been in. 

Anyway, I don't know if heating the tube helps, but in case it doesn't or you're like me and having tubes laying loosely around is not good enough, here are some clips to neatly run your tubes. There's one for the red and green planters from Butlers I own and a universal one to screw on to something with a 4mm screw (I've used 4x16mm in the pictures). 
And if you need something for the terracotta-colored Geli planters from third picture, I've split the Horrorprints's clip over at Thingiverse in Prusa Slicer and that worked out great.

As always, the source files are included, in case you want to adjust something or do your own clip based on the ones I did. And commercial use is still not allowed, because the part is designed with the Fusion 360 Personal License, too.