7 Wonders Second Edition Coin & Token Trays

This is a coin and military conflict token storage solution and game play enhancement for 7 Wonders Second Edition (Repos Production) — base game components only.

The trays are two tiers and fit stacked into the two compartments in the game's original plastic insert.

The top tray printed fine with no supports, but you might choose to print the bottom tray with supports. I had slight sagging/warping on the bottom trays with no supports, but it still turned out good enough for my standards and purposes.

I achieved similar results printing the bottom tray upright vs on an angle with a brim. I wouldn't recommend printing the bottom tray on an angle unless you have good bed adhesion (I have a glass bed).

You will print 1 of each of the top trays and 2 of the bottom tray. The (1) coins fit well in the top tray and (3) coins in the bottom. I achieved good results on my Ender-3 Pro 0.28 layer height 0% infill.

Note: the photos have an earlier prototype of one of the bottom tray without finger slots.

Hope this works well for you — feedback always welcome. Enjoy!