Drybox Drying bed

I have both an FDM and an SLA printer.

For the the SLA printer I use water washable resin. Which I wash/clean in a sonic cleaning bath. The thing is that when the model comes out of the cleaner it is wet and might even have absorbed a bit of moisture. In order to dry the models (a bit qicker then just air) I use a filament drybox.

This drying bed makes sure there is a stable surface for models to lay on and drip out onto tissues below.

Specs:

• 9cm by 13cm by 6cm (WxLxH)
• 10cm outer radius on the lower support (making it fit the curved surface at the bottom of the dryer)
• 1h40m printing time on my FlashForge Adventurer 4

The model is separated into the main bed and “legs”, making it easier to print flat on your FDM printer.