Elegant hanger NO DRILLING

Elegant hanger V1

Description

Simple model of an elegant hanger that can be glued to a door or a cupboard with double-sided tape. Not recommended for the wall. The model contains one hook, which has a small recess at the back for double-sided tape. I recommend to use the attached gcode.

Print Instructions

• Material: Use PETG or harder for best strength and durability. This model is optimized for PETG to ensure top performance and quality. I used “Prushament PETG Signal White”
• Print standing up: for better strength, print standing up as recommended by gcode
• Layer height: I recommend a layer height of 0.2 mm, but you can use other settings but the quality and smoothing to print speed ratio may be worse
• Fill: recommend between 20-40%, when higher the hook is heavy
• Supports: set everywhere

Don't forget to pick up a prushaments for the published copy, I'll be glad for the feedback