DIY modular storage system with drawers

A modular DIY storage system with drawers.

It's created as an insert into preexisting shelves - not a standalone piece. In case of using this separately, you need to add a top part and a bottom part to the plywood insert.

Recommended materials:
PETG
ASA
ABS

Printing in an enclosure is recommended to avoid warping. In case of printing without an enclosure, use a brim in combination with a draft shield.

Plywood insert:
Meant to be held together with wood glue.

Overall dimensions (without the handle of the drawers):
Height: 382mm 
Width: 835mm
Depth: 600mm
Width of the plywood: 5mm

Printable drawers:
Meant to be held together by screws and nuts.
Drawers: screws M3x6 and nuts (square M3)
Handle: screws M3x14, M3x20, and nuts (square M3)
 
Overall dimensions of the drawers (without the handle):
Height: 120mm
Width: 200mm
Depth: 590mm
Walls: 8mm