I recently replaced my old, former USB charger which was mounted under a desk with the new Anker Prime GaN Charger with 200W.
Therefor I created two brackets to mount this charger under a desk with 2 screws each.
There are two versions of the bracket; a tighter one which really holds the charger in place tightly and a slightly wider one in which you can add a e.g. double-sided adhesive tape to fit in between the clamps and the charger.
And for these two variants there are ones with holes for the screws and ones without (the latter can be used to add arbitrary holes in the slicer).
Printed in PETG, but should also work with PLA, used 4 perimeters for stability.
DISCLAIMER: Not affiliated with, or endorsed by, Anker in any way, shape, or form.
Rafts:
No
Supports:
No, print on side.
Resolution:
0.2mm
Perimeters:
4
The author marked this model as their own original creation.