Zeropanels door magnet holder

These magnet holders are used in conjunction with a zeropanels door, they work in the same way as the stock Voron 0 door magnet holders, but these are snap-in, use close to no filament, and print lightning fast. Also, since the door magnets are inside the frame, they are attracted much better than stock voron 0 ones.

Since they are not secured by screws you won't need preloaded nuts, and can slide up and down to match your door magnets. If you ever need to reprint them or wanna get the magnets back, just insert a small tip in the hole provided, and with a bit of force they will snap right off

Use 2 6x3 magnets per holder pair, just push them into their slot until you feel them snap, ensure proper polarities!

This design assumes a door with a 2mm foam tape strip as insulation, the holders attach with VHB tape

The standard size holders are nicer looking since they span the whole 1515 extrusion they are attached on, but they could interfere with some mods (e.g. hex-zero belt clamps). For this reason I also added a slim version to clear them