Vuvuzela Sturdy and Fast to Print 3 Parts

The cancer of musical instruments
2
24
0
102
updated December 28, 2024

Description

PDF

Made a stronger and easier to print version. Ideally it's glued together with a solvent weld like Weld-on 16. For middle and top files, place the wider piece on the print bed. For the bottom file place the mouthpiece down. I used a 5mm outer brim because the pieces are tall with little contact with the bed. I used inside supports for the bottom and middle pieces. On my Prusa i3 MK3 I was able to print two of each of the parts (two bottoms, middles, and tops) in a go, and get two complete "instruments" in about 4 hours.

UPDATE- since it's only 1 layer thick (when printing with a .8 nozzle, as I did), the strongest way to print these is individually in vase mode. If you cannot print in vase mode (if you are printing multiple parts at once), make sure the seam is NOT aligned, because a straight seam will lead to weakness.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

**Rafts:**

No

Supports:

Yes

**Filament:** Any PLA

Category: Music

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License