PTFE to Cable Clip Remix

I made this remix because I was starting to notice the cable slipping out of clip at the back where the wire separates from the PTFE tubing. That worked well but once I replaced the one I had to replace them all!

I included a couple of other ideas I was playing around with in case one of those designs might suit your specific needs better.

I printed the originals and this one in a good quality PLA and the original ones held up for nearly a year and the only real reason I replaced them was that slipping issue in the one, so I think PLA or PETG should work out okay for you.

Have fun and be sure to post a make when you're done!

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

No

Supports:

No

0.2mm

Infill:

100%

Notes:

Be sure to slow your printer down a bit since these don't have a very big foot print.

Changed the orientation of the clips to make them less likely to slip.