Instant Coffee Dispenser PiP (Print in Place) No Support Needed!

NO SUPPORT NEEDED
I printed it with 
PLA at 0.2mm layer height
10% infill
3 wall loops

Around 2 - 2.5 hours print

All files are already print ready and leveled for the bed, no need to rotate.

I used rough-grain instant coffee and i don't know if it works with fine-grain instant coffee, results may vary with fine-grain.

To use it: 
You assemble the parts like in the pictures
put the cover on, pull out the flat part of the chute from the outside, let the grain's fall into the chute, then hover over your desired mug, push the flat part into the dispenser and ta-da, 1 tea-spoon of coffee. Just repeat that as often as you need.

If you found any issues please let me know!