Stanchion sealing solution

Stanchion sealing solution. 

On my steel boat I do not like to use sika. It tends to stick to the paint and makes removal difficult when rusts develops under the seal. Using a rubber like this makes removing the stanchion easy and one can have quick and proper access behind and underneath the stanchion. Printed from black TPU and so far holding good. Will update if this changes. 

For fun I have included the templates I used to mark my non skid around the stanchions. 

Disclaimer

My models are always tested on my own boat. We are currently cruising to the Caribbean and you can therefor assume that we load up the part properly. It is however your own responsibility to use these parts when heading out to sea. Use common sense and print spares if you are not able to print onboard. Especially on longer passages. 

Remix

Please remix however you like. If you are not able to design your own parts I do offer a modification service to those in need. A contribution for my effort is however expected. Send me a message on Noforgeinland and I am sure we will figure something out. 
https://www.noforeignland.com/boat/sya