R31 Skyline Cup Holder

R31 Cup holder.

Designed to fit between the front seats in the cubby

I've tested in the cubby with a lid, but can't see why it wouldn't fit in the one without a lid also.

This was designed with the Australian Manufactured R31 in mind, but wouldn't be surprised if it fits Japanese or South African manufactured models as well.

Print in a heat resistant material. I used ABS.

The design incorporates a couple of holes to aid with removal from the car with a pick. You should also be able to use a M4 screw to seal the holes.

The top is a bit undersized. This is deliberate as the walls on my cubby were bowed inwards in the middle. Use foam mounting tape around the edge of the top to ensure a snug fit.

I used this tape as i had leftovers from a previous project. https://www.amazon.com.au/gp/product/B07JMC5R5V/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

I've designed this in 2 parts to avoid the use of supports. Print 1x top, and 2x cup. Once printed put the top upside down, push the cups in and if its not a tight fit use a bead of superglue to hold in place.

NOTE: This is not for commercial use.