Filament wall mount with MMU buffer V1
Description
PDF*** Having run this a few times it seems when the PTFE tubes are pulled together the friction increases significantly, this has caused me some problems, YMMV. I am thinking about solutions to this ***
V3 can be found here:-
https://www.printables.com/model/1015082-filament-wall-mount-with-mmu-buffer-v3
This works much better, but obviously feel free to try/adapt this one if you like!
Wall mounted spool holder. The spool mount section lifts up so you can place these next to each other and still change the spool.
Requires 2 PC4 M10 connectors for each mount and a 2 sections of PTFE tubing.
One Connector goes one the top left the other bottom right.
One section of PTFE runs from your MMU up the back of the mount to the top. The other runs from the top of the mount to behind the spool. The second piece of PTFE should be long enough to create a gentle loop from the end of the other length of PTFE to just short of touching the spool, if it is too long it can actually get stuck in the spool/filament (Speaking from experience!).
It's probably easier to see it in the pictures/videos.
There are 4 screw holes, I've found just two at the top are enough.
Any questions, please ask.
This is a work in progress but seems to work well as it is.
If you make this please share pictures, It gives me a warm fuzzy feeling to know someone else has liked my work enough to make it!
If you like my work and would like to make a small donation towards my efforts please click here
Tags
Model origin
The author marked this model as their own original creation.