Bambu Lab A1 LED Light Bar

Bambu A1 LED Bar Rear with mounts for the top of the printer. 

Nozzle: 0.4
Filament: PTEG
Infill: 25%
Wall Loops: 3
Supports: Yes, Tree

The LED strip, switch, 4-Pin connector are available at 3dMachinist Etsy Store

The LED Bar is 270mm long. It has been designed to allow the LED strip to slide into the bar, with the right side of the bar adjusted for the wire connector boot to slide in.

I did not use the 3M adhesive strip to attach the strip to my light.

If you would like, you can buy me a cup of coffee.

Increased the length of the LED Bar to 270mm and modified the width/design to allow for the LED strip to slide into the bar, with the right side of the bar allowing for wire connector boot to slide into the bar (leaving the 3M adhesive strip unused).   The LED light strip kit is available at the 3dMachinist Etsy store  This modified design uses the same mounts designed by the original creator: @Tobi_708284