Voron Trident / 2.4 parametric Wago 221 mount

I got an upgraded Fabreeko “Honeybadger” edge-to-edge bed for my Voron Trident and it's got a specific wiring configuration that enables you to switch it between a 110v or 220v configuration.  Nobody seems to have designed a mount for my particular configuration that didn't end up with extra wagos floating around.  And I knew that there was already an OpenSCAD library that would do Wago 221 mounts but it wasn't able to generate them with the holes and everything in the right place.

So I recreated the look and salient features of the stock Voron part in OpenSCAD with Joo Chung's code as a base.

It secures just like a stock mount, using M5x10 BHCS machine screws.

Print settings:

Use the Voron settings

• Layer height: 0.2mm
• Extrusion width: 0.4mm, forced
• Infill percentage: 40%
• Infill type: grid, gyroid, honeycomb, triangle, or cubic
• Wall count: 4
• Solid top/bottom layers: 5
• Supports: NONE

Also you want to use the same material that you would print a Voron out of.  This means probably ABS or ASA.  If you print it out as PETG it will warp.

OpenSCAD and BOSL:

I posted the OpenSCAD file as well as a mesh, if you want to use the OpenSCAD version, you need to install the BOSL2 library.  This means that you can generate any arbitrary

Rotated the screw holes 90 degrees and tweaked them to match the Voron design