Poop Chute Bucket for Bambu P1 & X1 Series with 8x3mm magnets

I took the original model from Makers Manual which suits my printing setup and environment perfectly. But I have a bunch of 8mm x 3mm magnets in my drawer and adopted the model accordingly.

The Makers Manual version is a remix, too, but contains some improvements compared to the original.

The magnets have a very tight fit. Depending on your printers tolerances a small drop super glue might be needed (but shouldn't).

Printed in:

• PLA
• 0.2mm
• print upright
• no supports needed

I made only one change:

Remodelled the magnet holes, so that 8mm x 3mm magnets can be inserted.