Dewalt Planer Vertical 4" Dust Hose Attachment

Designed to completely replace the internal dust collection system that blows the dust right out the back of a smaller diameter hose. 
 

I provide both the full model and a split version. The split version should print fine on a CR10 or Ender 3.

This part will require you to drill a 4" hole in the top cover. 
To do this, I used a 4" hole saw. To find the correct position, install the print using the factory screws, then set the cover on top of the print. Carefully align the cover such that it aligns with it's screw holes. I eyeballed it mostly off of where the handles and the top cover meet.  While holding the top cover in the correct place, reach in and trace around the print with a sharpie. That should give you the hole location.

There is a very small amount of play between the print and the 4" hole so take your time aligning it and tracing it. Or you could use a bigger hole saw and not worry as much… dealers choice.