OctoPrint Orange

OctoPrint Orange

- is a semi-open-frame case for the Orange Pi Zero 2w plus the expansion board with a 30mm fan and a mounting point for the antenna, designed to be mounted on the side of a horizontal 4040 rail, providing access to the buttons on the expansion board from the top, with the intention to be used for OctoPrint.
Notice: Many printers will likely need to be raised up to provide access to the USB, HDMI, and Ethernet ports.  See the bonus section for some extras that will likely improve your setup and experience.

Hardware Required

BONUS

Please take note of the BONUS folder that contains a few optional extras that are likely to make for a better experience.  Within, you will find:

• Printer Long Leg - Leg(s) for your printer that mount using screws and t-nuts and uses a 1 inch felt pad like these - https://www.amazon.com/dp/B01N8VO7OB/ - to reduce vibration and noise.
• USB Mount - 2020 or 4040 rail-mount adapter for a USB extension cable such as - https://www.amazon.com/dp/B07C87FYLY/
• X Keystones 4040 Mount - A series of brackets to mount keystones to the side of a 4040 rail to provide easy access to the various ports on the Orange Pi.  There are more than just Ethernet keystones, you can get USB (A, B, and C type), HDMI, Audio Jack, and More.  See this list for ideas. - https://www.amazon.com/hz/wishlist/ls/2UMIQEWSLSK28?ref_=wl_share 

All links are meant as examples only,  I don't get any kind of compensation, and I am not endorsing the source.

Happy Printing

  - Tumblefluff