Vertical Solder Spool holder XL 5LB spool variant

New XL 5lb spool model! 

For regular 1lb spools, see the original model.

To assemble, you need one 8x22x7 mm bearing (standard skateboard wheel bearing) and a m3 x 16mm machine screw. Click the bearing into the bottom piece and then click the top piece down onto it. It should be a snug fit, but not insanely tight. Then use the washer and m3 screw up through the bottom into the center pin on top. I would recommend adding some rubber feet to the bottom for additional grip to your table top.

I have included the .step file for easier remixing or if you need to adjust that top spool pin. It's 18mm in diameter which is perfect for 5 pound spools of Kester solder.

Enlarged and made thicker and stronger to support 5lb spools.