LED Strip Lamp

The assembly consist of 4 model and there print instructions are as follows

1. Print the ribbed base in your choice of color keep the in fill density 20% and try to use opaque material.
2. print lamp ribbed in vase mode using transparent/translucent material.
3. Print the diffuser in vase mode (rotate the model as larger diameter faces the build plate, make the top layer 0 and bottom layers at 4.
4. print the pole in any martial u like as it is only to support the LED strip.

Assembly 

1. prepare the LED strip by connecting wires and wrap it around the pole model.
2. the length of LED strip is depend upon the amount of light you desire more the length tighter the wrap pitch more will be the illumination.
3. place the pole model into the base and superglue it on place therefore it will stay in its place.
4. put the diffuser on to the base and glue it.
5. Test the LED and illumination.
6.  place the lamp model on the slot of the base model.