Articulating Raspberry Pi HQ Camera MK3 Frame Mount Opinionated

This is a mix of several models related to the Articulating Raspberry Pi Camera Mount

I made the following changes

• added a build plate that contains all parts for the configuration I tested
• z rotation comes first (close to the case), then all other axes are around y' . At the end there is the ball joint. I found this configuration quite intuitive to manipulate into any desired position, reducing the amount of screws to loosen and tighten for position changes.
• fuses two models for the PI HQ Cam case, to get a slightly better shielded mount

Print without additional support, it is already configured for the parts

Printed with 0.15 mm layer height, PLA, 0.4 mm nozzle

I also tried to print the screws horizontal to avoid that they break at layers, but the additional support was difficult to clean from the screws, and made them quite hard to move. I found that stability is not an issue for PLA at 6 mm screws when printed upright. My guess if they break is: Make sure your filament is dry, even for PLA.

License inherited from other models I remixed.