Stickybones Finger Replacement

My friends were having trouble frequently losing the finger modules from the Stickybones drawing figure. They were also having trouble sourcing authentic replacements, so they asked if I could print temporary replacements while they wait for theauthentic replacements they ordered.

This model includes the fingers (and thumb joint) only. They were rescaled to be a firm, but still posable, fit on an authentic Stickybones hand.

Printing Information

• I printed with PLA
• I used a 0.4mm nozzle, but smaller nozzles should be fine.
• Print with Supports I found organic supports to work the best.

Geometry of the original was modified and rescaled to make the fingers fit a Stickybones hand model without falling off easily.