4" Vinyl siding camera support

The inside of the support has a hollow part to allow the wiring to be stored.  It is a tight fit but it all gets inside which allows for a neat storing.  You will have to adjust the screws you want to use depending on how you print this.

I used the screws that came with the camera to install on the wall and selected four more screws to install the camera to the support.

I used ABS with 5 walls and 15% infill.  Print standing up and no support required. The extra walls are to allow your screws to grap onto something when putting the camera on.  If you use screws that are too big for the holes the unit will split (trust me).  The holes of the camera unit base are 3.2mm in diameter.  The ones to screw into the plastic support are 3.7mm in diameter.  The holes to allow the screws to go all the way to the back of the plastic support to screw into the wall are 7mm.

There is a side hole on the printed part to connect the power to the camera.  It is 11.5mm and it allows the power connection to get into the unit.

Of course, step files etc are included.

I hope it helps you out.