Starbond Caddy

Holds the standard Starbond CA glue (x3), accelerator, a spot for the tips and caps. I rounded the bottom of the trough for the tips and caps so it's easier to slide the parts out.

The other caddy's I printed here had too tight of tolerances and my CA glue bottles wouldn't fit.

These are actual measurements I got after printing: ID of CA glue cylinder: 37mm ID of accelerator cylinder: 55mm Width: 90mm Length: 195mm Height at the CA glue holder: 35mm Height at the Accelerator holder: 55mm

My print looks crappy because I cranked up the speed and layer height to 0.4mm. Printed at 15% infill, plenty good for this.