WIG / TIG filler rod / welding wire HT DN40 organisation system

I cut a 1 meter pipe into two parts. The lower part is 80 cm and the upper part 20 cm.

You need:

• 1x Wandhalter Boden (Wallmount bottom)
  • The diameter of the holes are bigger than the pipe's diameter because it has to fit the lid (Deckel)
• 1x Wandhalter Wand (Wallmount Wall)
  • it has nearly the same geometry as the first part but misses a bottom and has nearly 4 cm diameter. The pipes fit very tight, so maybe you need a bit of lubricant
• 4x Verbinder (Connector)
  • One side has a diameter of nearly 4 cm to fit the upper part of the pipe very tight.
  • The other side provides more space
  • Togehther with the upper part the connector is the lid for the filler rods
• Inlays as you want
  • I used the Inlay that splits the pipe into two parts for the 1kg 1 meter SG2 rods with 2.0 and 2.4 diameter
  • I used an Inlay with more sections to store VA2 (and soon Alumunium rods 
• Lids (Deckel Boden) or Lids (Deckel Boden Innen) depending on whether you have a pipe without  pipe socket (then a “Deckel Boden” can be used) or with pipe socket (then the “Deckel Boden Innen” fits into the socket)

In my pictures the pipes have not the same length.

This is due to a misunderstanding of the concept of the HT pipes. The socket's length is not included in the overall length of the length of the pipe. So I bought a 1 meter pipe and got a 110cm pipe (where the socket is around 10 cm long). I noticed that a little bit to late :-( But it has no effect on the functionality.