Nema 17 back cover

I was going to use this to make some wire management changes to my printer but decided to go a different route. You can use this for any purpose.

It's a snug fit (won't fall off even during fast printing) that goes on the back of a standard NEMA 17 stepper motor. It has a hole in the end mostly for weight concerns but also allows some heat from the motor dissipate better than if it were closed up.

If you find a use I would love to see what it is.

Print Settings

Printer Brand:

LulzBot

Printer:

No

Supports:

Any

Infill: