Honda Passport Dash Cubby Tray--OpenScad

My wife puts a couple of tubes of lip balm/moisturizer along with a box of mints in her Honda Passport's dash cubby, but everything was rolling around and sometimes even falling out! This tray fixes that with two slots for lip balm tubes and another area for mints or other items. The slots for the tubes are angled down to keep them a bit more secure. There is a small lip around the front to hold the additional items in place.

I printed in PLA with 0.3mm layer height, 15% infill, no supports. I use a 0.6mm nozzle and it printed in 1 hr. 53 min.

An OpenScad model is included in case you want to remix to add a different arrangement of dividers. It uses the Round-Anything library to make a fairly good fitting tray.