Tray for Mixing Epoxy

This is a simple tray to mix epoxy in that can be easily discarded after use. Print using 0.4mm nozzle. Base is 0.2mm thick, print at 0.2mm layer height so it prints in a single layer. Sides are 0.5mm in diameter so they print in a single pass (similar to vase mode).

Print Details:

• Parts: The model prints in 2 parts – the spatula and the tray.
• Layer Height: 0.2 mm 
• Infill: 10% with grid pattern
• Supports: No supports required
• Filament: Red Bambu Basic PLA+
• Printing Temperature: 220°C
• Bed Temperature: 55°C

This printed in under 5 minutes on my Bambu P1S, this is slightly more elegant than using a sheet of paper, but does pretty much the same thing \_(ツ)_/. Happy Printing!