Recommend a Prusa printer, earn $30! See the updated Prusa Rewards Program.

Cubicle mount for IKEA SKÅDIS board

0 reviews

C 5

Cicatrice

@Cicatrice_2313952

A fast-printing (no support) mount to attach an IKEA SKÅDIS board on any cubicle wall, without screw or glue.

353

updated August 6, 2024

Description

PDF

Cubicle wall + IKEA SKÅDIS = 🤝

This mount is perfect to attach a SKÅDIS board to any cubicle wall (or basically anything flat and hard enough to handle hooks).

It helps adding a bit of personal touch in a corporate space.

Installation requires no tool, screw or glue.

TL;DR:

Use skadismount_parametric.scad to tune your model
Print at least two pieces
Mount your SKÅDIS board on your cubicle wall

Printing

Printing settings

Infill: 100% (can probably be reduced)
Printing duration: ~1h for two pieces
Layer height: 0.24mm (can probably be adjusted)
Support: no
Material: tested with generic PLA

Printing instructions

Check carefully the following values before printing:
- Distance between board and wall (update spacer)
- Wall thickness (update board_t)
Adjust all parameters in OpenSCAD based on your need.
Export STL file from OpenSCAD.
Your piece should be ready for printing.

Parametric model tuning

The STL provided is here as a sample for 20mm board. As cubicle wall can be from any thickness, you may need to tune this model a bit into OpenSCAD.

All values below are in millimeters.

Parameter	Description
`board_t`	The thickness of your cubicle wall. You may eventually want some margin.
`extra_top`	Length of the extra height on top of the model. For stability and solidity.
`extra_bottom`	Length of the extra height at bottom of the model. For stability and solidity.
`spacer`	Distance between board and wall. Adjust it to the feet you may use in board corner.
`top_bracket`	Add a bracket on top of the model for solidity.
`back_t`	Thickness of back bar of the model.
`top_t`	Thickness of top bar of the model.

Usage

Installation

This mount does not require any tool, screw or glue to install.

Attach mounts on the back of your SKÅDIS board, at same height.
Hang the board on your cubicle wall.
Ensure it is stable, and strong enough before adding anything on the board.

Recommandations

Use at least two mounts for stability

Disclaimer

⚠ Despite this model is perfectly fitting my usage, and is supporting a typical load (SKÅDIS board + my stuff attached to it), it has not been strictly tested.
Nobody can guarantee it will fit your usage. Use at your own risks.

Model origin

The author marked this model as their own original creation.