Death Star lamp Stand

CAUTION: When I printed this I forgot to add tolerances so I had to sand the parts so they fit together. Afterwards I added .2mm tolerances for the parts that fit together, but did not print them again, this MAY or MAY NOT be enough for your printer/material, so expect some sanding to make everything fit.

The Star itself if from a lamp like this: https://www.amazon.co.uk/Star-Wars-Rogue-Plastic-colour/dp/B01LW806P1
I changed the stock leds and installed bluetooth-controlled RGB ones:
https://i.imgur.com/6xwPaAh.mp4

I finished the parts with several layers of filler primer and putty and a lot of sanding, and then glued most of it togther and painted it. Trying to finish or paint after building would be a pain.

Some parts need to be printed several times, the name of the file says how many.

Print Settings

Supports: 

Yes

Resolution:

0.2mm
 

Notes: 

I mostly printed everything with 3 perimeters to allow for some sanding without worring about breaking anything. It doens't have to withstand a lot of weight so the infill can be just enough to support the parts.