Wavy Bauble - Vase mode

For best results print with a .8 nozzle at .6 layer height in vase mode for a robust bauble that will print in ~20mins and use very little material.

This was designed using Slice-Up which is a tool for directly generating gcode so was really built around the .8 nozzle - I've then converted it from gcode into an stl - I haven't tested it with smaller nozzles yet but it is a watertight model so no reason it wouldn't work - I'd keep an eye on the print though if you try it just to be sure!

Recommend your standard nozzle/settings for the hanger which can just be glued on after printing :)

Photos are models printed in 3DJake two tone PLAs