Magnetic Connector for AC Infinity 100mm/4" Inline Fan to 102mm Hose

Magnetic connector for a AC Infinity 100mm/4" Inline Fan to 102mm hose (Phonitec in my case), using 12x 10x3mm magnets (per side) and a TPU seal.

I always use some duct tape on the flange of the inline fan, to have some kind of sealing, 
thus the connector is not 100% snug, unless you do the same.
But then it's fitting perfectly, even without any clamp.

The hose connector is quite long, since Phonitec hoses have two layers (sound dampening).
The part before the stop is for the inner hose, the other half is for fixing the outer layer.

Regarding the seal:
I usually put them on the hose side to keep things flexible and just glue it in. 
Works fine so far :)

If you are not interested in the magnetic part / want to keep it simple, you can also just print the hose connector, connect the hose to it and stick the flange side on the inline fan.
Works fine as well.

(I also made the same for the Carbon Filter. 
Please let me know if you are interested, then I will upload it as well.)

Remix based on https://www.printables.com/model/282014-parametric-vacuum-hose-connector-with-magnetic-con