A stand for mounting two HA210NO6 MOSFET modules and two 40mm fans. I found the MOSFETS here: https://www.amazon.com/gp/product/B07TWL385B
The fans are probably not needed & the fan mounts can be deleted if desired. If you want to use them, there is a cut-out on the stand that matches their dimensions. Use a bit of CA glue to attach them side to side within the cutout. I attached the mounts as seen in the photos, but never installed the fans as the heatsinks never get warm enough to warrant additional cooling measures when installed on my Ender 3.
The MOSFET product description included the following:
Dimensions: 70 x 45mm/ approx 2.76 x 1.77"
Distance between holes: 62.8mm x 37.8mm/ approx 2.47" x 1.49"
Supply/Operating Voltage: 12V-50V (12-24VDC recommended)
Max Current: 30A(Enhance heat dissipation) safe for prolonged times. ensure active cooling of the heatsink.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/guBrK1u7ZF6
Category: 3D PrintingThe author marked this model as their own original creation. Imported from Thingiverse.