Candle Mold - Half-X

A candle-mold in the form of a Half-X, just because it sounds better then V-candle…

Splits in 4 parts: Baseplate, 2x Shells (They are mirrored but still listed as 1 and 2 if any changes happens) and a wickholder on the top.

Designed to print without supports.

Print the body upside down.

Needs 3pcs M4x30mm (or similar in size), 6pcs washers, 3pcs M4 nuts.

I use size 18 wick (approx 2x3mm in size for 50mm candles).

Designed to thread the wick around and tie off in the top.

Print in PETG or ABS to prevent deforming.
The candle-wax i'm using melts around 60-65c. Too much for PLA.