Unifi U7 Pro Wall - Table Stand

For this model you will need :

• 4 M3x4mm Threaded Heat Set Inserts 
• 4 M3x6mm Flat head screws

The mounting plate used is the one supplied with the access point.

This model was printed with :

• ASA Filament (Aurapol Signal White)
• Layer Height : .2 mm
• Wall Loops : 4
• Top Shell Layers : 4
• Bottom Shell Layers : 4
• Infill : 30%
• Support : Yes - Tree Manual
• Brim : Yes - Outer