WAGO 221 DIN rail clip holder with label

Easy to print DIN rail Clips for WAGO 221-415. Based on OV1A's design.
Made it wider to match the width of the 221-415 and added a section on top that acts as room for a label and as a lever for easier removal of the clamp from the Rail.

Will fit slimmer Wago 221-models as well, but the holder will obviously stick out to the sides.

Based on a Model by Jens Petersen (https://www.thingiverse.com/ov1a/designs) - satisfying snap when attaching to the rail, holds the Wagos tightly, so you can open and close them while in the holder.

Category: Electronics