Shaving Can Rust Saver

A small piece to clip over the bottom of a metal shaving foam can to prevent rust getting onto your bathroom tiles. Scaled to fit a can of Gilette Fusion Hydra Gel can - 53.4mm diameter. Has a few drain holes to stop water building up in it.

Designed to print with no supports, and doesn't require any particular layer height (I normally use 0.20mm).

If you need a different size and don't know how to use Fusion 360 (it's easier than you think), leave a comment with the width of the can you use and the height you need (normally need about the height of the bevel plus 5mm).