Push-fit peg / screw mount for Multiboard Underware

This small push-fit peg allows screwing Multiboards (https://www.multiboard.io) under a desk (or onto any other surface), initially designed for use with Hands-on-Katie's Underware (https://www.printables.com/model/941161-underware-the-ultimate-cable-management-solution) using a small-head screw, in my case a SPAX WIROX 3x16. Its countersunk screw head is too small for the pegboard hole. 

I print these with the same paramters as Multigrid. 3 outer walls, 15 % infill. But it probably doesn't matter too much.  

Due to the angle of the major hole (90°, same as the screw head) and depending on your printer's overhang capabilities, you might see some print defects in the angled taper, but these should not affect the usage of the print. The pressure from the screw will compress them. 

I have not done any tests on what the weight bearing capacity of this is. But considering it's meant for use with Underware, I doubt too much weight will be put on them. If you want to mount heavy stuff though, I would probably suggest to use Multiboard's DS Snaps. 

Made with FreeCAD.