Yeethammer 2-4x Shell holder

This part replaces the “cam-track-cover” on the Yeethammer to enable mounting of shell holders. The part is designed for the left side, but can be mirrored (X-axis) in your slicer to fit the right side. You may choose to install 1 or 2 shell holders on the cover.

Hardware needed

You will need longer screws to fit the plate.

• 2x M3x16 for mounting the cover plate to the Yeethammer.
• 4x M3x16 for mounting 2 shell holders to the plate.
• 4x M3 nuts on the backside of the plate. I used some CA glue to hold them in place.

Print instructions

The model is oriented in its intended printing orientation. Mirror the cover-plate on X-axis for right side mounting. Designed for 0.2mm layer height. Make sure you have good bed adhesion, or use a brim/skirt to make sure the shell holders won't warp during printing.

Some adjustments on the mounting holes for the Shell holders to fit the Yeethammer plate.