Blender Calibration Cube

Scratch built cube using the Voron calibration cube dimensions with Blender Logo on each side. Enjoy :)

To check for dimensions and tune accordingly, this cube should be printed as is in 30x30x30 mm. This guide can help you tune your printer in according to this model - AndrewEllis Print-Tuning-Guide

If you want to tune your printer for printing parts made by Voron Design, then please make sure to follow the recommended printing guidelines (can be found on every Voron Design printer manual in the introduction):

3D PRINTING PROCESS: Fused Deposition Modeling (FDM)
MATERIAL: ABS
LAYER HEIGHT Recommended: 0.2mm
EXTRUSION WIDTH Recommended: Forced 0.4mm
INFILL TYPE: Grid, Gyroid, Honeycomb, Triangle or Cubic
INFILL PERCENTAGE Recommended: 40%
WALL COUNT Recommended: 4
SOLID TOP/BOTTOM LAYERS Recommended: 5

Usage:

1. check dimensions of 30x30x30 mm
2. check overhangs on the Voron Logos on the sides
3. check bridge on the inside 
4. test fit the top 625 2RS bearing
5. test fit of bottom F695 2RS bearing
6. check for ringing of the axes on the opposing sides of the X and Y symbols
7. tune accordingly

More information about this test print can be obtained on Voron's GitHub page. https://github.com/VoronDesign/Voron-2