I had some issues installing SKF bearings and mainly dust seals on my forks on triumph street triple 675r. I had created and printed some variation of some fork driver I downloaded to 41mm. But, after successfully installing the bearing, I could not make it to install that dust seal. That is why I redesigned the driver to v2 where one side can be used for the bearing itself and the second side for the dust seal.
Triumph street triple 675r uses 41mm forks, the SKF bearing & dust seal has 41x53.3x…
With some little tweaks it can be used for another forks as well.
I did not test this model yet, I am just right now printing it when I am adding this file.
Printed with PLA, 4 perimeters and 40% infill. But I have added 2 modifiers for the top 13mm and bottom 10mm for 8 perimeters.
Unfortunately, I designed that model in centimeters, so it has to be scaled to 10% or I added the 3mf project where the model is already scaled down and contains that modifier (orcaslicer).
The author marked this model as their own original creation.
