Pokemon Go++ AirTag Holder
Description
PDFI lose my Pokemon Go++ often enough to need a tracker on it. I tried attaching an AirTag via the lanyard clip but didn't like how it would vibrate against the AirTag and buzz incredibly loud. I ended up combining two models - linked below - to achieve a solution.
I recommend printing upright, with organic supports, for cleanest results. You may be able to print with the AirTag side down, but I found doing so both extended the print time and generated significantly more support material that was difficult to remove cleanly.
Tolerances should be tight enough that it doesn't rattle when the device vibrates, even after extended use. I had an issue with a previous iteration of this model rattling as the plastic expanded over time, and addressed that issue by securing it with a Zot between the model and the Go++. The AirTag fits “backwards” into holder, ie, metal side facing down.
Remixed from:
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
Removed clip of model and added AirTag holder from Thingiverse model
