Table Top Skee Ball (Jumbo Shrimp size)

Largish miniture Skee Ball game.  Manual scoring, but I made it large enough I was thinking going back and modifying it to add electronic scoring and perhaps a servo control ball return.  Printed the main game in PLA, and the balls in TPU.  The softer balls keep the over bounciness down to an acceptable level. 

I created a ball launcher but found I do about as well with a finger.  I will include that.  The launcher that is, not my finger.  Getting the rubber band tension right gives the launcher more fine control.  The launcher is not necessary but can add a dimension to the game.

I switched filament color while printing the face to get the white on black, just paused the print swapped the filament and continued.  This is fairly large and probably have to print at 75% scale on a standard size printer.  Should still play fine and save about half the filament to print at ¾ scale.

For the numbering I printed the letters in TPU then attached to tape, glued the back of the numbers, applied that to the face, and peeled the tape once the glue was set.  

I glued the lane pieces and the base parts together.  The rest can just sit on that without glueing.  Have not printed the face screen yet.   I will probably play with the ramp design a bit more as that really affects the playability of the game.